Permits after the fact
I enclosed my garage or carport without a permit in Manatee County. How do I make it legal?

You make a garage or carport you enclosed without a permit in Manatee County legal with a permit for the room as it's built. That means drawings of what's there and what must change, signed and stamped by an architect or engineer registered in Florida, then the county's review, then inspections by a private provider, in my experience in Manatee County (an inspector the owner hires, such as a licensed engineer, architect or building code administrator, to inspect in the county's place). Our drawings name what the room will be used for, because the use decides the rules: any permitted enclosure means smoke alarms in the house, a bedroom also needs an escape window (egress window), and a room people live in should sit, I've found, at least as high as the house's floor, or in a flood zone as high as the county's flood rules set.
This post is for homes in unincorporated Manatee County (outside the limits of any city or town), where Manatee County Development Services issues the permit (Manatee County). If your home is inside the City of Bradenton, Palmetto, Holmes Beach, Anna Maria or Bradenton Beach, or the Town of Longboat Key, your city's or town's building department handles it (Bradenton, Palmetto, Holmes Beach, Anna Maria, Bradenton Beach, Longboat Key). A Bradenton or Palmetto mailing address doesn't settle it: on our jobs, homes with those addresses were outside city limits and permitted by the county. Check whether your lot is inside city limits.
After the fact, the permit starts with drawings of the room as it stands

At Thresh Architects we've drawn three enclosures like this in Manatee County:
- A garage whose two doors were filled in with block and windows (2024)
- An enclosure beside a garage, in a flood zone (2025 to 2026)
- A carport already converted into rooms and flagged by code enforcement (2026)
For the 2026 carport, I told our drafter the goal was "plans that are drawn properly, but as close as possible to what they have," meaning drawings that meet the code while changing as little of what the owner built as the code allows.
Drawings are needed because the county reviews them against the code and the inspector checks the room against them.
Manatee County's house permit checklist asks for plans "signed/sealed by a registered Florida design professional," with "existing and proposed floor plans for renovations." It also asks for a survey (a measured drawing of the lot and the house on it) sealed by a surveyor and the energy calculations form (which shows the room meets Florida's energy code). For the outside windows, doors and siding the work uses, it asks for a Florida product approval number (the number showing the state approved it).
Our after-the-fact jobs have gone through the same steps, from the permit application and its forms to the Notice of Commencement (a form recorded with the county before the first inspection, F.S. 713.135). Our post on what happens when code enforcement says you need a permit for work already done lays them out in order.
The permit for an enclosure starts with measured drawings of the room as it stands, and the drawings then show what must change to meet the code.
Any permitted enclosure means smoke alarms in the house, and a room someone sleeps in also needs an escape window

When a sleeping room is added, or other work that needs a permit is done, the house must have smoke alarms. Work only on the outside of the house, like a new roof or new siding, is exempt; an enclosure adds a room, so it isn't. There must be one in each sleeping room and one outside each sleeping area (a Florida Building Commission training course).
The Florida Building Code says "every sleeping room shall have not less than one operable emergency escape and rescue opening" (as Pinellas County quotes it). Such an opening is a window you can open, big enough and low enough to climb out of in a fire. Its opening must be at least 5.7 square feet (5 square feet on a floor at ground level). It must be at least 24 inches high and 20 inches wide, with its bottom no more than 44 inches above the floor.
These rules come from the 2023 code, and the next edition is scheduled to take effect December 31, 2026 (Florida Building Commission). A permit applied for after that date may fall under the new edition.
If anyone will sleep in the room, the drawings must show an escape window that meets the code.
Outside a flood zone, a room people live in should sit at least as high as the house's floor
I've found a living space's floor must sit higher than the crown of the road (the high middle of the street). A room at the same height as the house's floor needs no check against the crown. A lower floor may sit below it, and only a survey that measures the heights of the floor and the road, beyond the one on the checklist, can tell, which adds cost.
On the 2026 carport, the room sat a few inches below the house's floor and wasn't drawn as a bedroom. When a room sits lower like this, I tell the owner they "cannot use it as a bedroom," and that raising the floor "would require a survey and all these other documents, which is going to be thousands of more dollars."
We still drew a 37 by 62 inch escape window and a smoke alarm in the room itself, so the room would be safe if anyone ever slept in it.
A room lower than the house's floor can't be a bedroom, in my experience.
An enclosed garage or carport below a flood zone's required floor height is only for parking, storage or access

In the flood zones whose names start with A, Florida's code puts a house's lowest floor at or above the base flood elevation (the flood height on the flood map) plus 1 foot. It says any enclosed area below that must "be used solely for parking of vehicles, building access or storage" (Florida Division of Emergency Management). That area must also have flood openings, often called flood vents.
Flood vents that aren't engineered (the standard kind, not designed by an engineer for that wall) must add up to at least 1 square inch for each square foot of the enclosed room and sit on two or more sides. Their bottoms must be no more than 1 foot above the floor or the ground outside, whichever is higher. A door or window counts only if a flood vent is built into it.
On the 2025 to 2026 enclosure beside a garage, which we drew as enclosed storage, we added three flood vents in the drawings' first revision. It had 276 square feet enclosed, so by the rule the vents had to add up to at least 276 square inches.
Manatee County asks owners who apply for a permit for an attached garage in a flood zone to sign a Non-Conversion Agreement. The owner agrees to use the space only for parking, storage or access and records the promise on the deed. The form warns that an unauthorized conversion "may render the structure uninsurable by the National Flood Insurance Program or increase the cost for flood insurance."
An enclosed garage or carport below a flood zone's required floor height needs flood vents low in its walls, in the zones whose names start with A.
In a flood zone, work costing half the building's value can mean the whole house must meet today's flood code
Manatee County's flood page says its 50% rule covers work whose cumulative cost "equals or exceeds fifty (50) per cent of the market value of the building." Cumulative cost means all the work in one year added together. Ask the county how it would count the cost of your work against the building's value. Our post on mobile homes explains how the county counts it, including work already built.
From what I've seen, when the cost of the work reaches that line, the whole house has to meet today's flood code. The house usually doesn't meet it and may have to be torn down. So on a flood-zone job we often work to keep the cost of the work and the building's value "balanced right." That means the cost of the work stays under the county's 50% line.
In a flood zone, keep the cost of the work under half the building's value.
The drawings also need the door into the house, product approvals, the wiring and the ground lowered at the new wall
- A door from the room into the house. In my experience, under single-family zoning an enclosed carport or garage has to connect to the house by an inside door. Without one, the county reads the room as a second home on the lot.
- A Florida product approval for every new outside window and door. Clients almost never have these approvals or the energy calculations, so we provide them.
- An electrical layout showing the outlets, switches, smoke alarms and the electrical panel, as the county's checklist asks.
- The ground lowered at the new wall, since a garage slab often sits level with the ground outside. For the carport, I called for six inches on the drawings from the top of the old slab down to the ground outside.
Put these on the first set of drawings, since in my experience the county won't issue the permit without an electrical layout, and waiting on product approvals stalls the job.
Inspections come last, and the room has to match the drawings
I told our drafter, "because it's an after the fact project we have to use a third party inspector." In Manatee County, I've found this inspector is a private provider, in a flood zone or not. In my experience these are two separate things: the flood rules are one check, and the building inspections on after-the-fact work have still gone to a private provider. Florida law lets a licensed engineer, architect or building code administrator be one (F.S. 553.791).
Manatee County's written policy says home alterations and additions in a flood zone "will be reviewed and inspected entirely by the Manatee County Building Division." In a flood zone, ask the county at the start who will inspect.
In my experience, the inspector may see "something there that is not perfectly aligned with the drawings." Then "he will say bring that up to the drawings" (change the work to match). He may also say to "get the drawings revised" (changed to show the work as it's built, where that still meets the code).
A private provider's visit before the drawings can also turn up problems, like siding with no sheathing (the board layer behind the siding). On one job the drawings then called for sheathing and a water barrier (a wrap that keeps rain out of the wall). If the inspector needs to see work that the finished walls now cover, part of a wall may have to be opened to show it. That post says more about opening walls.
By the last inspection, the room and the drawings have to match, because the inspector checks one against the other.
Sources
- Manatee County, "Apply, Search and Manage Building Permits"
- City of Bradenton, Building and Permitting Division
- City of Palmetto, Building Department
- City of Holmes Beach, Building Department
- City of Anna Maria, "Frequently Asked Questions"
- City of Bradenton Beach, Building & Planning
- Town of Longboat Key, Building Division
- Manatee County Development Services, "One & Two Family Submittal Checklist"
- Florida Statutes § 713.135, Notice of Commencement
- Pinellas County, "2023 Florida Building Code" (emergency escape and rescue openings, Section R310)
- Florida Building Commission (hosted course), "Smoke and Carbon Monoxide Alarms Advanced, 2023 Florida Building Code"
- Florida Building Commission, "9th Edition (2026) FBC Code Update Development Tasks" (Oct 2026)
- Florida Division of Emergency Management, "Guidance for Attached Garage and Enclosure Floors/Slabs and Flood Openings" (Jan 2024)
- Manatee County Floodplain Management, "Non-Conversion Agreement" (2026)
- Manatee County, Flood information (flood zones, the 50% rule, the flood risk search)
- Florida Statutes § 553.791, private providers
- Manatee County, "Private Provider Program, Projects in a FEMA Special Flood Hazard Area"
Let’s talk